About the role
Gramian Consulting Group is recruiting a Senior PCB Design & Hardware Simulation Engineer for a remote position in Egypt. The arrangement is a full-time Independent Contractor engagement requiring 40 hours per week. Its Duration is Approximately 13 weeks, with possible extensions, and the Start Date is As soon as possible. Using KiCad, the engineer will investigate, redesign, simulate and validate hardware with attention to Signal Integrity (SI), Electromagnetic Compatibility (EMC), thermal behavior or a combination of these areas. Layout changes must preserve the existing schematic, netlist connections and component choices.
What you will do
- Turn product requirements into circuit architecture, hardware specifications and validated designs.
- Develop or update KiCad schematics and multilayer PCB layouts, including component selection, routing, design-rule checks, BOM preparation and manufacturing records.
- Inspect existing PCB layouts and simulation findings to locate signal-integrity, EMC and thermal problems.
- Determine underlying causes and set measurable acceptance conditions for proposed improvements.
- Correct board layouts while keeping the original schematic, selected components and netlist connectivity unchanged.
- Execute and interpret simulation work covering impedance, reflections, crosstalk, return paths, heat dissipation, thermal hotspots and temperature distribution.
- Assess inputs, material characteristics, boundary conditions, assumptions and model limitations.
- Document design choices, remedial work, simulation findings and verification evidence.
- Contribute to prototype bring-up, design validation and hardware debugging.
Requirements
- 8+ years of relevant engineering experience overall, with extensive practical work in electronic hardware and PCB design.
- At least 6 years of direct electronics-hardware and PCB-design work, including multilayer board layouts.
- Practical use of KiCad for schematic capture and board design.
- At least 4 years of applied work in Signal Integrity (SI) / Electromagnetic Compatibility (EMC) simulation, thermal simulation and analysis, or both.
- Strong grasp of circuit analysis, component selection and electronic-component datasheets.
- Sound knowledge of power distribution, grounding, signal integrity, thermal management, Design for Manufacturing (DFM) and Design for Test (DFT).
- Ability to independently prepare, run, interpret and validate the relevant engineering simulations.
- Experience comparing simulation output with actual PCB layout characteristics and finding design causes behind performance problems.
- Ability to judge model inputs, material properties, boundary conditions and simulation constraints.
- Strong technical writing and problem-solving skills.
- Ability to carry out technical tasks independently and translate simulation evidence into measurable design improvements.
Benefits
Potential extension opportunities are available after the Approximately 13 weeks engagement.
How to apply
Use Gramian Consulting Group’s official vacancy to apply and follow the directions provided there.